Compatible Stair tool for below models
Dyson DC01/02/03/04/05/07/14Good Quality New Compatible Swivel tool
£3.99Search our catalogue below
Dyson DC01/02/03/04/05/07/14Good Quality New Compatible Swivel tool
£3.99Dyson DC01/02/03/04/05/07/14Good Quality compatible Tool Kit(Please note due to the Design the Crevice tool will only sit on board the DC14 models)The crevice tool however will still fit the above models on the hose and wand
£9.99These belts are only for the clutched versions of the models stated in the title. It includes:1 x Small belt1 x Large BeltBelts are made to the same specification as the original belts*PLEASE NOTE: THESE BELTS WILL FIT AS STATED, THEY WILL ALSO BE SMALLER THAN THE BETLS ON YOUR OLD CLUTCH, DUE TO THE OLD BELTS BEING STRETCHED OVER THE YEARS. IF YOU YOU FIND THESE BELTS TO TIGHT TO FIT, THAT IS BECAUSE EITHER YOU HAVE ORDERED THE WRONG ONES, OR STRUGGLING TO FIT THEM (NON FAULT OF THE PARTS). PLEASE ONLY BUY IF YOU ARE CONFIENT IN FITTING THEM*BRAND NEW
£2.99Genuine Dyson Reclaimed On/Off switch for the following models DC03DC04DC05DC07DC08DC14DC15DC19DC33Due to stock colour of switch might vary, however it will still do the same job and work the sameThis is a 2 prong switch that will work with most of the Dyson vacuums (not DC01, DC02 or cordless machines)The photo shows a BAR Switch however as these are sent at random due to stock you might receive a black or Brown switch insteadWhile this is a used part it has been fully tested by our engineers.
£1.15Various Colour choices in the drop down box below Without these your head assembly will vibrate and move, causing structural issues on the head assembly. Which can result in Breakages round the footplate, Vibration, Brush bar movement etc. These will fit the following Models: DC03 - DC04 - DC07 - DC14 - DC27 - DC33Buy more than one set and save on postage
£0.89Genuine Dyson DC07 Crevice tool will sit on board all dc07 modelsHowever even though it does not sit on board the following models it does however still fit on the hose and wandsSuitable For: DC01/02/03/04/05/07/14
£2.99These Soleplate Screws hold your Soleplate on your Dyson to the Brush housing on the bottom of your vacuum, These fit across multiple Models, These push into place once you have removed previous worn out screw. Reason for replacing is if undone the wrong way or years of use can wear the undo point and become harder to take off when you are needing to remove the soleplate.These are available in silver or yellow, please contact us before you purchase if you are after a certain colour as these sets are sent at random.
£1.99