DC01 Spares

Quick viewAdd to wishlist

Dyson DC01 Filters - 8 Pack

Dyson no longer make these filters, however we are able to offer these great after-market alternatives. These will fit all versions of the DC01 vacuums. The filter locations for these on your machine is one in the yellow cage down the side of the motor and the other sits above the motor. Now if you have a HEPA machine then the filter above the motor will be a purple plastic one, we do stock and sell that filter and it can be found below.Or if you want to save money we also sell it as a kit, again this can be found below

£2.99
Quick viewAdd to wishlist

Genuine Dyson DC01 Used Yellow Hose Assembly

This hose has been fully cleaned and inspected. It is free from any splits or cuts. As a reclaimed item, some signs of previous use may remain, this does not affect performance. Will fit all versions of the Dyson DC01 vacuums, but will not fit the original DA001 models (before the DC01). If in doubt, please do message us. The above picture is a stock photo, colour will also vary. If you are after a certain colour please notify us before purchasing and we will let you know if the colour you require is available.If you can not see the DC01 part that you are after, please contact us and we will have a look. If the part is available we will get it added to the website. 

£14.99
Quick viewAdd to wishlist

Genuine Dyson Used DC01 Wand Pole Yellow.

This wand has been fully cleaned, checked and is in full working order. As a reclaimed item, some signs of previous use may remain. Will fit all versions of the Dyson DC01 vacuums, will not fit the earlier DA001 models.Photo is a stock photo, due to amount of stock of these some may be a little more faded than the one in the photo. This is to be expected from the age of the machine. We will however, only send one that is in full working condition and not broken.

£19.99
Quick viewAdd to wishlist

ORIGINAL QUALITY DYSON DC01, DC04,DC07,DC14 VACUUM CLEANER BELTS 2 PACK

If the belt on your Dyson has snapped, there is no need to worry. These belts are not only easy to fit, but because they are made to the same quality as a genuine part, you are getting great belts at a low cost.Each pack contains 2 belts (keep one as a spare)To Fit: Place round the brush roll first, then stretch the belt over the motor spindle.Please Note: Please check that your brush spins freely before fitting, also make sure to look for any damage. Once fitted check to make sure that the belts have not got twisted when fittingMODELFITMENT: DC01,DC04,DC07,DC14

£2.99